Maytag RJRS4280D Manual Del Usuario página 12

AUTOMATIC ICE
KER
After the refrigerator hasbeen connected
to the water supply,move the wire lever
arm on the icemaker into the clown
(ON) position to start its operation.The
icemaker will fill with water when the
freezer reaches the proper temperature.
It may be 8 to 12 hours before the ice-
maker furnishes any usable ice cubes.
Discard all the cubes from the first two or
three batches made.These initial ice cubes
may be irregularly shaped, discolored, or
contain impurities from the new water
supply piping.
When the ice cubes are ejected it is
normal for several cubes to be joined
together at the ends.They can easily be
broken aparcThe icemaker will continue
to make ice until the supply of ice cubes
raises the wire lever arm, shutting the ice-
maker off.
To manually stop the operation of the ice-
maker, move the wire lever arm into the
up (OFF) position,
Certain sounds may accompany the vat-
iouscycles of the icemaker.
• buzzing of the water valve
• running of the water as the tray fills
• rattling of the ice cubes falling into an
empty ice bin,
If the ice is not used frequently, the ice
cubes will become cloudy, shrink, stick
together and taste
stale. Empty the ice
storage bin periodically
and wash it in luke-
warm water. Rinse and
dry thoroughly.
ICE
To check the
ice [eve[ or gain access to
the ice bin, lift the door on the bin.
TO REMOVE THE BIN:
• Turn off the icemaker by moving the
icemakerwire lever arm up to the OFF
position.
• While holding the top edge of the ice
bin, grasp the lower edge of the ice bin
and pull down to release the latch, then
pull ice bin out.
° Reverse procedure to replace the ice
bin.
• Turn the icemaker on by lowering the
wire lever arm.
NOTE:
Beverages and foods should NOT be
placed in the ice storage bin for quick
chilling.These items can block the wire
lever arm, causing the icemaker to mal-
function.
II