Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
CONDENSER
Cleaning of the condenser is recom-
mended every 3-6 months.
TO CLEAN:
• Remove Machine Compartment cover
(see page4).
• Turn the power to the unit off using the
Main Power switch.
NOTE:
Turning the power off on the elec-
tronic control panel inside the refriger-
ator stops cooling only in both com-
partments. It DOES NOT turn off
power to the unit.
• Use the soft
brush vacuum
attachment
to loosendust
and lint
on
the condenser fins.Vacuum to remove
the soil.
• After cleaning, turn the Main Power
switch back on.
• Replace the machine compartment
cover.
LIGHT BULB
REPLACEMENT
UPPER
FRESH
FOOD
AND
FREEZER COMPARTMENTS
There are light bulbs at the top of each
compartment.
WARNING:
Always re-
member
to turn
OFF ("O')
the
power
to the refrigerator
at the
main power
switch and to wear
gloves when replacing light bulbs.
TO ACCESS THE UPPER LIGHT
BULB AREA IN EITHER
COMPARTMENT:
LL
JJ
•
Push
in on
_
_
r
the
finger- __1
:
_
tabs located
behind
the
electronic control panel at the top of
the compartment.
• Lower the light shield.
• Replace the burned out bulb(s) with
standard AI 5-40 watt appliance bulb(s).
Available from your dealer.
• After
replacing
the bulb(s),push
the light shield
up into its orig-
inal position.
LOWER FRESH FOOD
COMPARTMENT
There is aTS-40 watt bulb located behind
each OptiFresh
TM
drawer. Replacement
bulbs are availablefrom your dealer.
IMPORTANT:
• To avoid damageto the OptiFresh
TM
drawers, power must be turned off
at the Main Power switch (seepage4)
before changingthe bulb.
TO REPLACETHE
BULB BEHIND
THE UPPER OPTIFRESH
TM
DRAWER:
• Turn the power off to the refrigerator
at the Main Power switch in the upper
machine compartment (see page 4).
• Unload
and
remove
the
upper
OptiFresh
TM
drawer.
• Remove the OptiFresh
TM
air diverter
located at the rear of the fresh food
compartment.
• Lift up and remove the glass shelf.
Air Diverter
Strip
Shelf
After
the
shelf
is
//_/
removed, 2 mounting
Ii_1
screws
are
visible
behind the
drawer. 7_g_=-_\
Using a ¼" hex head
screw driver, remove
these screws.
• Slidethe compartment assembly forward.
• Unscrew the bulb and replace with a
new T8-40 watt bulb.
• Slide the assembly back into its original
position.Align the screw holes, making
sure air ducts are in alignment. Replace
the two screws. Replace the shelf and
the air diverter
strip. Reinsert the
drawer into the compartment.
• Turn the power to the refrigerator back
on.
IMPORTANT:
• Do
not
remove the foam piece
between the OptiFresh
TM
drawers.
19
Publicidad
