Corghi A 2024 Manual De Uso página 28

- Once you have mounted the bottom bead,
repeat the same steps for the upper bead
(fi g.21).
- Tilt the tower back, free the wheel and take it
off the tyre changer.
Special tools
To facilitate mounting/demounting of low-profi le
tyres, it is advisable to use the bead presser pliers
(optional accessory).
INFLATION
WARNING
Tyre infl ation is a dangerous operation. Always
infl ate tyres in the strictest observance of the
following instructions.
ATTENTION
During this stage of operations noise levels of
85 dB(A) may be present. We recommend that
the operator wears hearing protectors.
WARNING
During the bead insertion and infl ation proce-
dure, safety goggles and ear defenders must
be worn.
DANGER
The machine, even if it limits pressure, does not
provide suffi cient protection against exploding
tyres during infl ation.
Failure to observe the following instructions will
make tyre infl ation extremely dangerous.
DANGER
USERS MUST ABSOLUTELY NEVER exceed
the pressure recommended by the tyre manu-
facturer. Tyres may explode if infl ated beyond
these limits or the structures may incur serious
damage not visible at the time. KEEP THE
HANDS AND BODY WELL CLEAR OF THE TYRE
DURING INFLATION. Make sure you are well
concentrated during this stage of operations
and make frequent checks on the tyre pressure
to avoid the risk of excess infl ation. Exploding
tyres can cause serious injury or death.
28
Infl ation (A 2024 only)
The machine is equipped with a tyre infl ation
pedal and a pressure gauge for reading the tyre
pressure.
- Release the wheel from the sliding clamps on
the table top.
- Bring the horizontal arm to the fully extended
position.
- Lower the vertical rod until it touches the
rim.
- Lock the horizontal arm and the vertical rod in
the positions described above fi g.26.
- Connect the Doyfe infl ation chuck (21) on the
air hose to the valve stem.
Infl ate the tyre by pressing the pedal briefl y and
repeatedly; check the pressure gauge frequently
to make sure that the pressure NEVER exceeds
the maximum pressure specifi ed by the tyre
manufacturer.
Infl ation (MTS 20" - MTS 24" only)
- Release the wheel from the sliding clamps on
the table top.
- Bring the horizontal arm to the fully extended
position.
- Lower the vertical rod until it touches the
rim.
- Lock the horizontal arm and the vertical rod in
the positions described above fi g.26.
- Connect the Doyfe infl ation chuck (21) on the
air hose to the valve stem.
Infl ate the tyre by operating the gun briefl y and
repeatedly; check the pressure gauge frequently
to make sure that the pressure NEVER exceeds
the maximum pressure specifi ed by the tyre
manufacturer.
Infl ating tubeless tyres
(T.I. versions only)
WARNING
Before carrying out the operations described
below, always make sure that there is no dirt,
dust or other impurities on the jaws near the
air outlet holes.
- Make sure that the wheel is secured to the table
top with inside clamping.
- Connect the Doyfe infl ator chuck (21) on the air
hose to the valve stem.
- Hold the tyre with your hands and lift it until
there is a slight gap between the lower bead
and bottom edge of the rim in order to close
the upper bead and the top of the rim.
Operator's manual MTS 20" - MTS 24" - A 2024