Kärcher KIRA CV 50 Manual Del Usuario página 20

Fitting the battery packs
1. Open the battery compartment cover.
2. Press one or two battery packs into the battery pack
holder on the device until you feel it/them latch into
place.
3. Close the battery compartment cover.
Downloading the app and connecting the
device
To be able to use all available functions we recommend-
ed downloading the Kärcher KIRA Robots app, see Ac-
companying product information.
Connect cleaning robots with the Kärcher KIRA Ro-
bots app:
1. Download the Kärcher KIRA Robots app.
2. Open the Kärcher KIRA Robots app.
3. Log in or create an account.
4. Follow the step-by-step instructions in the App.
Operation
ATTENTION
Danger due to obstacles
Risk of damage
Before operating the cleaning robot, make sure that
there are no obstacles on the floor, stairs or landings.
ATTENTION
Risk of damage to the floor
During cleaning, small parts could get caught in the
Cleaning brush and scratch the floor.
Before each cleaning process, check the Cleaning
brush for small parts that are stuck.
ATTENTION
Risk of damage
The cleaning robot does not recognise escalators,
which can cause the device to fall.
Keep the cleaning robot away from escalators.
20
Rules for operation
● Keep the floor free of objects lying around to ensure
efficient cleaning. Obstacles require time-consum-
ing cleaning because the cleaning robot has to drive
around objects.
● Open the doors of the rooms that were also open
during the creation of the map and are to be
cleaned.
● For cleaning in Routine mode: Carry out the config-
uration in the app so that the cleaning robot can
clean according to individual cleaning requirements
(no-go zones, different cleaning parameters, etc.),
see chapter Adaptation options in the app.
● Danger zones and areas that the cleaning robot is
not allowed to enter must be demarcated in the map
beforehand either manually or with a no-go zone.
Switching on the device
1. Keep On/Off/Pause button pressed for 3 seconds.
The device starts up.
2. Wait until the dashboard appears on the display.
Note
When starting up the device for the first time, wait briefly
until the SIM card establishes reception.
3. Press any button.
The main menu appears on the display.
The settings can be accessed in the main menu under
"Settings".
You can choose between Normal mode and Eco mode,
see chapter Suction strength.
1. Select the "Notifications" button in the "Settings"
main menu.
English
Settings
Suction strength
Notifications