Publicidad
Idiomas disponibles
Idiomas disponibles
● Create schedules
Select a map on the cleaning robot and start
cleaning
Note
The cleaning robot must be placed in the starting area
marked on the map before cleaning. The starting area is
approx. 2 m x 2 m and corresponds to the place where
the cleaning robot started creating the map. The starting
area can be subsequently moved in the app. The labels
supplied with the device can be attached to the wall or
a hard floor to mark the start area. The labels are not de-
tected by the device, but merely serve as a guide for the
user.
Note
Check the sensors for dirt and clean them with a damp,
lint-free cloth if necessary.
1. In the "Cleaning" main menu, select the button "Ex-
isting maps".
A list of the stored maps appears on the display.
2. Select the desired map and confirm with "Confirm"
button.
The cleaning robot starts cleaning.
3. Once cleaning is finished, the cleaning robot returns
to the starting point.
The display shows the time needed for cleaning and
the size of the cleaned area.
A detailed cleaning report is available in the app.
Create scheduled cleaning
1. A scheduled cleaning can be created in the app via
the "Tasks" tab.
Assign card to a device
A card can be assigned to one or more cleaning robots
in the app via the "Maps" tab or via the cleaning robot
detail view.
Initially, the map is assigned to the cleaning robot with
which it was created.
Exchanging battery packs
● If the battery charge is less than 20%, a notification
appears on the display of the device and in the app
indicating the need to replace of one or both battery
packs so that the cleaning robot can continue clean-
ing.
● If the battery charge is 10%, the cleaning robot stops
cleaning and returns to the starting area. A message
appears on the display and in the app.
Note
The cleaning robot can only continue cleaning after the
battery packs have been replaced.
If the battery packs are not replaced, the cleaning robot
switches off.
1. Open the battery compartment cover.
2. Remove the battery packs (see chapter Removing
the battery pack).
3. Insert the battery packs, see chapter Fitting the bat-
tery packs.
4. Close the battery compartment cover.
5. Confirm with "Confirm" button.
Cleaning continues.
Interrupt or end cleaning
1. Press the On/Off/Pause button.
Cleaning is interrupted.
A message indicating that cleaning has been
paused appears on the display for 3 seconds.
2. Confirm with "Confirm" button or wait 3 seconds.
The options "Continue cleaning", "Back to starting
point", "End cleaning" appear on the display.
3. Select the desired setting using the arrow keys and
confirm with "Confirm" button.
Depending on the selection, the cleaning robot con-
tinues cleaning, returns to the starting point or stops
cleaning.
Note
If the child lock is enabled during the interruption, it
needs to be unlocked before making a selection.
If the PIN lock is activated during the interruption, a
message appears on the display. The code must be en-
tered using the arrow keys and then confirmed before
making a selection.
Switching off the device
1. Keep On/Off/Pause button pressed for 3 seconds.
A prompt appears on the display asking whether the
cleaning robot should really be switched off.
2. Confirm with "Confirm" button.
The cleaning robot switches off.
Removing the battery pack
1. Open the battery compartment cover.
2. Press the battery pack unlocking button.
The battery pack pops a few centimetres out of the
battery pack holder.
English
23
Publicidad
