Kärcher B 150 R low wheel pressure Manual Del Usuario página 25

 Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
 Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
 Align the holder of the cleaning head so
that the drilled holes in the lever and the
cleaning head match.
 Insert the stop pin through the bushings
and swivel the locking plate downward.
 Slide the drawbar in the guide channel
on the cleaning head all the way to the
bottom.
 Repeat process on the drawbar on the
opposite side.
 If necessary, adjust the brush level us-
ing the draw bar lock nuts.
 Insert the grey intelligent key.
 Set brush type "Disc".
Install R cleaning head
 Lift the holder of the cleaning head (see
Chapter "Grey intelligent key/.../clean-
ing head replacement".
 Slide the cleaning head under the appli-
ance so that the hose points toward the
rear.
Only slide the cleaning head halfway
under the appliance.
 Pull out the cover.
 Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
 Push in the cover.
 Slide the cleaning head halfway under
the appliance.
 Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
 Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
 Align the holder of the cleaning head so
that the drilled holes in the lever and the
cleaning head match.
 Insert the stop pin through the bushings
and swivel the locking plate downward.
9
-
EN
 Insert the cylinder pin into the boring of
the drawbar.
 Slide the drawbar with the pin the guide
channel on the cleaning head all the
way to the bottom and lock.
 Insert the locking plate into the guide
channel and lock it in.
 Repeat process on the drawbar on the
opposite side.
 If necessary, adjust the brush level us-
ing the draw bar lock nuts.
 Insert the grey intelligent key.
 Set brush type to "Roll".
Remove D cleaning head
 Press in the locking plate and swivel the
drawbar upward.
The subsequent removal will take place in
the opposite order of the installation.
Remove R cleaning head
The removal will take place in the opposite
order of the installation.
Replacing the brush rollers
 Lift the cleaning head.
 Loosen the lock of the wiper flap.
 Swivel the wiping flap out of the way.
25