Kärcher B 150 R low wheel pressure Manual Del Usuario página 26

 Loosen the lock of the wiper flap.
 Push the bearing lid down and remove.
 Pull out the brush roller.
 Insert a new brush roller.
 Reattach the bearing lid and the wiper
flap in reverse sequence.
 Repeat process on the opposite side.
Replacing the Disk Brushes
 Lift the cleaning head.
 Press the pedal for changing the brush-
es downward beyond its resistance.
 Pull the disc brush out of the side below
the cleaning head.
 Hold the new disc brush under the
cleaning head, push upward and lock.
Replacing the side brush (only with SB
version)
 Loosen 3 screws.
 Remove the wiper blade.
 Push in the new side brush.
 Tighten 3 screws.
Frost protection
In case of danger of frost:
 Empty the fresh and dirt water reser-
voirs.
 Store the appliance in a frost-protected
room.
26
Troubleshooting
DANGER
Risk of injury! Before working on the appli-
ance, remove the Intelligent Key and the
mains plug of the charger.
Pull out the battery plug.
 Drain and dispose of the dirt water and
the residual fresh water.
CAUTION
Risk of injury due to overrun of the suction
turbine.
Suction turbine will continue to run for a
while after switch-off. Carry out mainte-
nance tasks only after the suction turbine
has come to a halt.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Fault indication
If errors appear on the display, then pro-
ceed as follows:
Fault indication as text
 Execute instructions on the display.
 Acknowledge the fault by pressing the
info button.
Fault indication as numerical code
 Turn the program selection switch to
"OFF".
 Wait till the text on the display has dis-
appeared.
 Turn the programme switch into the
previous position.
Only carry out the troubleshooting
measures in the indicated order if the
error occurs again. The key switch must
be in the "0" position and the emergen-
cy stop button pressed.
 If the fault cannot be repaired, call cus-
tomer service and mention the error
message.
Note:
Fault messages that are not listed in the fol-
lowing table indicate faults that cannot be
rectified by the operator. Please contact the
aftersales service.
10
-
EN