Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
INDOOR UNIT
Setting Angle of Air Flow
Setting vertical angle of air flow
While the unit is on, use the SWING/DIRECT
button on remote control to set the direction
(vertical angle) of airflow. Please refer to the
Remote Control Manual for details.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long
periods of time. This can cause water to
condense on the louver blade, which will drop
on your floor or furnishings.
When using COOL or HEAT mode, setting the
louver at too small an angle can reduce the
performance of the unit due to restricted air
flow.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See Fig. B)
and manually adjust it to your preferred
direction.
The DIRECT button on the remote will adjust
the angle of the louvers 6 degrees at a time.
Manual Operation (without remote)
CAUTION
The manual button is intended for testing
purposes and emergency operation only.
Please do not use this function unless the
remote control is lost and it is absolutely
necessary. To restore regular operation, use the
remote control to activate the unit. Unit must
be turned off before manual operation.
To operate your unit manually:
1.
Open the front panel of the indoor unit.
2. Locate the MANUAL CONTROL button on the right
hand side of the unit.
3. Press the MANUAL CONTROL button one time to
activate FORCED AUTO mode.
4. Press the MANUAL CONTROL button again to
activate FORCED COOLING mode.
5. Press the MANUAL CONTROL button a third time to
turn the unit off.
6. Close the front panel.
Page 14
NOTE: Do not move louver by hand.
This will cause the louver to become
out of sync. If this occurs, turn off the
unit and unplug it for a few seconds,
then restart the unit. This will reset the
louver.
CAUTION: Do not put your fingers in
or near the blower and suction side of
the unit. The high-speed fan inside the
unit may cause injury.
Publicidad
