Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
SLEEP: Gradually increase the temperature in COOL mode or decrease the temperature in
HEAT mode.
The SLEEP function is used to gradually decrease energy use while you sleep and don't
need the same temperature settings to stay comfortable. This function can only be
activated by the remote control. The SLEEP function is not available in FAN or DRY
mode.
Press the SLEEP button when you are ready to go to sleep.
When in COOL mode, the unit will increase the temperature by 2°F (1°C) after 1 hour,
and will increase an additional 2°F (1°C) after another hour.
When in HEAT mode, the unit will decrease the temperature by 2°F (1°C) after 1 hour,
and will decrease an additional 2°F (1°C) after another hour.
The sleep feature will stop after 8 hours and the unit will continue to operate.
TIMER ON/TIMER OFF
The timer can be used to delay the appliance start up or shutdown, this avoids wasting
electricity by optimizing operating periods.
TIMER ON: The TIMER ON function allows you to set a period of time after which the unit will
automatically turn ON.
Press the
24 hours.
Point the remote to the indoor unit and wait 1 second. The TIMER ON will be
activated.
TIMER OFF: The TIMER OFF function allows you to set a period of time after which the unit will
automatically turn OFF.
Press the
to 24 hours.
DIRECT: Pressing this button adjusts the angle of the louvers 6 degrees at a time.
ECO: This is an energy saving function that operates in COOL mode.
When the set temperature is below 75°F (24°C) the temperature will automatically adjust
to 75°F (24°C) and the fan speed will change to AUTO.
When the temperature is above 75°F (24°C) the temperature will remain unchanged and
the fan speed will change to AUTO.
Pressing the ECO button again or adjusting the temperature to less than 75°F (24°C) will
stop ECO mode.
Page 38
buttons to set the start up time from 30 minute increments up to
buttons to set the start up time from 30 minute increments up
Publicidad
