Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
NOTE ABOUT WIRING
THE WIRING CONNECTION PROCESS MAY DIFFER SLIGHTLY BETWEEN UNITS AND
REGIONS
1. Bundle the drain hose, refrigerant pipes, and signal cable as shown below.
DRAIN HOSE MUST BE ON BOTTOM
Make sure that the drain hose is at the bottom of the bundle. Putting the drain hose at the top
of the bundle can cause the drain pan to overflow, which can lead to fire or water damage.
DO NOT INTERTWINE SIGNAL CABLE WITH OTHER WIRES
While bundling these items together, do not intertwine or cross the signal cable with any other
wiring.
2. Using adhesive vinyl tape, attach the drain hose to the underside of the refrigerant pipes.
3. Using insulation tape, wrap the signal wire
refrigerant pipes, and drain hose tightly
together. Double-check that all items are bundled.
DO NOT WRAP ENDS OF PIPING
When wrapping the bundle, keep the ends of the piping unwrapped. You need to access them
to test for leaks at the end of the installation process (refer to Electrical and Gas Leak Checks
section, Page 30 of this manual).
Page 20
Publicidad
