Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
• Secure the mounting plate to the wall with the screws provided. Make sure that mounting
plate is flat against the wall. Screws should be secured into studs in the wall.
NOTE FOR CONCRETE OR BRICK WALLS:
If the wall is made of brick, concrete, or similar material, drill 0.2" (5mm) diameter holes in the
wall and insert the wall anchors provided. Then secure the mounting plate to the wall by
tightening the screws directly into the wall anchors.
WARNING: Suitable screws will need to be used for the specific type of wall to properly anchor
the air conditioner.
Step 3: Drill wall hole for connective piping
1. Determine the location of the wall hole based on the position of the mounting plate.
Refer to Mounting Plate Dimensions.
2. Using a 2.5" (65mm) core drill, drill a hole in the wall. Make sure that the hole is drilled
at a slight downward angle, so that the outdoor end of the hole is lower than the indoor
end by about 0.2"-0.275" (5mm to 7mm). This will ensure proper water drainage.
3. Place the protective wall cuff in the hole. This protects the edges of the hole and will
help seal it when you finish the installation process.
CAUTION:
Make sure there are no pipes or wires behind the wall before drilling or cutting the hole.
Page 16
Publicidad
