Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
Step 2: Install drain joint (Heat pump unit
only)
Before bolting the outdoor unit in place,
you must install the drain joint at the
bottom of the unit. (see Fig. A)
1. Fit the rubber seal on the end of the
drain joint that will connect to the
outdoor unit.
2. Insert the drain joint into the hole in the
base pan of the unit.
3. Rotate the drain joint 90° until it clicks in
place facing the front of the unit.
4. Connect a drain hose extension (not
included) to the drain joint to redirect
water from the unit during heating
mode.
IN COLD CLIMATES
In cold climates, make sure that the drain
hose is as vertical as possible to ensure
swift water drainage. If water drains too
slowly, it can freeze in the hose and flood
the unit.
Step 3: Anchor outdoor unit
The outdoor unit can be anchored to the
ground or to a wall-mounted bracket with
M10 bolts (not included). Prepare the
installation base of the unit according to the
dimensions below.
UNIT MOUNTING DIMENSIONS
Prepare the installation base of the unit
according to the dimensions below.
30.12"
21.85"
Page 23
Publicidad
