Franke CG 981 M M Manual De Instrucciones página 27

Removing the oven door
To facilitate oven cleaning, the oven door can be removed (see Fig. 4a, Fig. 4b and Fig. 4c), operating on the hinges
as follows:
– The hinges (A) have two movable saddles (B). Lift the saddle (B) to release the hinge.
– Then lift the door up and pull it outwards; to do this, hold the door at the sides near the hinges.
– To refit the door, firstly insert the hinges in the special grooves.
– Before closing the door, remember to turn the two movable saddles (B) previously used to release the two hinges.
Replacing the oven lamp (Fig. 7)
Franke ovens are equipped with two rectangular lamps. To replace the oven lamp, proceed as follows:
– turn off the power to the appliance by means of the omnipolar switch used for connecting it to the electrical system,
or disconnect the plug if accessible;
– remove the glass cover (A), prising it off with a flat screwdriver;
– remove the lamp and replace it with one resistant to high temperature (300 °C), having the following characteristics:
Voltage: 220/240 V ~ 50-60 Hz
Power: 25 W (SM 981 P) or 15 W (all other models)
Connection: G9 for halogen bulb (SM 981 P) or E14 small (all other models).
Note: It is advisable not to touch the lamp with hands; use a cloth or a piece of absorbent paper.
Assistance
In case of any operation problems, contact a Franke After-Sales Service Centre (refer to
the enclosed list).
Never resort to unauthorised technicians.
Specify:
– type of fault;
– appliance model (Art.);
– serial number (S.N.).
This information is given on the appliance dataplate, on the warranty certificate.
Safety instructions
• The Manufacturer declines any liability for damage due to: incorrect installation, improper, wrong or unreasonable use.
• This appliance is not intended for use by persons (including children) with limited mental or motory abilities or without
experience and knowledge of it, unless supervised or instructed in its use by someone responsible for their safety.
• Children must be supervised to ensure that they do not play with the appliance.
Always contact qualified personnel in the following cases:
To ensure safe and efficient operation of this electrical appliance:
– only contact authorised service centres;
– always demand the use of original spare parts;
– the appliance is designed for non-professional household use; do not modify its characteristics;
– the dataplate gives the symbols indicating the countries for which the instructions apply;
– appliance electrical safety is guaranteed only when it is connected to an earthing system in compliance with the
current regulations.
– Do not touch the heating elements or any parts of the oven door during use, as they become very hot.
Keep children away.
Do not allow children to touch:
– the controls and the appliance in general;
– the packing elements (bags, polystyrene, staples, etc.);
– the appliance during and immediately after oven use, since it becomes very hot;
– the appliance when not used (make any potentially hazardous parts safe).
Do not:
– touch the appliance with wet parts of the body;
– use the appliance when barefoot;
– pull the appliance or power cable to unplug it from the socket;
– carry out improper or hazardous operations;
– block the ventilation and cooling openings;
– leave the power cables of other electric appliances on hot parts of the appliance;
26