Motorola APX NEXT XN Guia Del Usuario página 31

5.4
Attaching and Removing the RSM
Attaching the RSM to the Radio
Prerequisites: Ensure the contacts and the connector interface are clean and free of foreign material.
NOTE: To ensure proper operation, turn off the radio before connecting the RSM to the radio.
Connecting the RSM to the radio disables the speaker of the radio, but does not disable the microphone
and PTT of the radio. Refer to MN008306A01, XVN500 IMPRES
Manual for the operating instructions.
Procedure:
1. Attach the RSM connector to the side connector of the radio.
2. Secure the connection screw in a clockwise direction until tightened using a coin.
Removing the RSM from the Radio
Procedure:
Unscrew and detach the RSM connector from the radio side connector.
5.5
Attaching and Removing the Accessory Connector
Cover
To prevent damage to the accessory connector, shield it with the connector cover when not in use.
Attaching the Accessory Connector Cover
Procedure:
To attach the Accessory Connector Cover, perform the following actions:
a. Insert the hooked end of the cover into the slot above the connector.
b. Press the top of the cover down to seat it in the slot.
c. Rotate the thumbscrew clockwise to tighten the cover.
Result:
MN008401A01-AF
Chapter 5: Getting Started
™ Remote Speaker Microphone User
31