Micropoint qLabs ElectroMeter Plus Manual De Instrucciones página 88

7. Powering the qLabs
Plus ON and OFF
7.1 Power Connection
The qLabs ElectroMeter Plus comes with a power supply which must
®
be plugged into the qLabs
Alternatively, the qLabs
batteries (See Section 12.2).
The messages on the four-cell grid displayed at the
bottom of the screen provide hints for the functions of the
buttons.
7.2 Powering the qLabs
LANGUAGE
ENGLISH
ITALIANO
FRANçAIS
SKIP
OK
OPERATOR ID
ON
OFF
SET MEM
VER
When qLabs ElectroMeter Plus is in the standby mode, you have two
®
choices to power on the monitor:
1) Press and hold the "Power" button for 2 seconds to turn on the
ElectroMeter Plus power supply jack.
®
ElectroMeter Plus can use 4 standard AA
®
ElectroMeter Plus On
®
When the qLabs
initially powered on, it beeps and enters the
"LANGUAGE" screen.
Use "á" or "â" to select desired language
and then press "OK" to enter the next
screen; or press "SKIP" to skip the language
selection and enter the next screen directly.
If a language is selected when the meter is
initially powered on or it is manually selected
in the "LANGUAGE" screen and "OPERATOR
ID" function is "ON", the meter beeps when
powered on and enters the "OPERATOR ID"
scanning screen automatically. After finishing
the scanning, the meter prompts the user to
insert a strip.
If a language is selected when the meter is
initially powered on or it is manually selected
in the "LANGUAGE" screen and "OPERATOR
ID" function is "OFF", the meter beeps when
powered on and prompts the user to insert a
test strip automatically.
10
ElectroMeter
®
ElectroMeter Plus is
®
EN EN EN