9. Perform a Test
9.1 Entering Test Mode
OPERATOR ID
ON
OFF
SET
MEM
VER
OPERATOR ID
123456789
OK
LOGOUT
TEST TYPE
PATIENT TEST
QC TEST
OK
PATIENT ID
When the qLabs
®
turned on by pressing the "OK" button, if
"OPERATOR ID" function is "ON", the meter
enters "OPERATOR ID" scanning screen
when powered on, press " " to finish the
scanning and the meter prompts to insert a
test strip.
If "OPERATOR ID" function is "OFF", the
meter prompts to insert a test strip when
powered on.Go to Section 9.2 for test strip
insertion.
When the qLabs
®
turned on by inserting a new test strip, the
meter enters "OPERATOR ID" scanning
screen when powered on. After finishing the
scanning, the meter enters the "OPERATOR
ID" confirming screen.
Press "YES" to enter the "TEST TYPE"
screen. Press "LOGOUT" to return to the
"OPERATOR ID" scanning screen.
Select "PATIENT TEST" from the "TEST
TYPE" screen and press "OK", the display
screen will prompt the user to enter patient
ID or enter the Strip Code if patient ID
function is turned off.
19
ElectroMeter Plus is
ElectroMeter Plus is
EN