Micropoint qLabs ElectroMeter Plus Manual De Instrucciones página 98

9.2 Insert a Test Strip
If the input of patient ID is set to ON, go to Section 9.3 for entering the
patient ID; otherwise, jump directly to Section 9.5 for entering the Strip Code.
9.3 Entering the Patient ID
PATIENT ID
9.3.1 Manual Input
PATIENT ID
A000
- ----------
NEXT
-
OK
9.3.2 Auto Scan
Remove a fresh test strip from its foil pouch.
Insert the strip into the test strip guide.
The following two observations indicate that
you inserted the strip correctly:
1) The electrode leads go in first.
2) You can read test strip name clearly on
the end of strip, left to right.
The Patient ID can be composed of numbers
or letters, with a length of no more than 16
digits.
Press "
or press " " to input Patient ID via barcode
scanner.
Use "+" and "-" buttons to change the
highlighted digit. Press "NEXT" button to
accept and advance to next digit.
If the input of the Patient ID is completed,
press "OK" button to accept.
+
In the Patient ID INPUT/SCAN interface,
press "SCAN" and scan the patient barcode
from a distance of approx. 15cm (6 inches).
The meter beeps once the barcode has been
read successfully. The barcode information
appears in the CONFIRM interface.
If a barcode is not scanned, the scanner
turns off after 10 seconds.
20
" to manually input the Patient ID
EN