Micropoint qLabs ElectroMeter Plus Manual De Instrucciones página 94

INVALID
PASSWORD
8.8 Bluetooth Settings
BLUETOOTH
OFF
BACK
-
OK
8.9 Lot Number Setup
LOT NUMBER
ON
BACK
-
OK
NOTE: Please make sure the date setting is correct if you want to use the
input function of LOT NUMBER.
8.10 Backlight Setting
BACKLIGHT
ON
BACK
-
OK
If the password is incorrect, the screen
shows "INVALID PASSWORD" when "OK" is
pressed and skips to "OPERATOR ID" screen
after 2 seconds. The setting of function
switch is still the same as before entering the
password.
Press "+" or "-" buttons to turn on/off the
bluetooth. When the Bluetooth function is
on, the user can use optional Bluetooth
dongle to connect the meter to the user
management software.
Please refer to the Data Manager manual for
+
Bluetooth driver installation and usage.
You can press the functional "+" and "-"
buttons to enable or disable the LOT
NUMBER input function. If the LOT NUMBER
input function is enabled, you will be asked
to enter the Lot Number before performing
+
each test. The Lot Number contains the
expiration date of the strip or liquid control.
The meter will check whether the current
date exceeds the expiration date of the strip
or liquid control. If the current date exceeds
the expiration date, the meter will report an
error.
Use "+" or "-" to turn on or turn off the
backlight function.
+
16
EN