tormek T-1 Manual Del Usuario página 12

EN
Replacing the diamond grinding wheel
DISASSEMBLY: Hold the
diamond grinding wheel with
one hand and loosen the grind-
ing wheel nut using a 19 mm
wrench. Note: The nut is
loosened clockwise because
it has left-handed threads.
Replacing the composite honing wheel
DISASSEMBLY: Hold the
diamond grinding wheel with
one hand and loosen the grind-
ing wheel nut using a 19 mm
wrench. Note: The nut is
loosened clockwise because
it has left-handed threads.
Next, install the wave washer.
The wave washer slides onto
the shaft from the grinding
wheel side.
1 2
1
Pull the composite honing
wheel and shaft out slightly so
the diamond grinding wheel can
be removed past the guide.
Loosen the honing wheel by
holding the composite honing
wheel with one hand and
loosening the honing wheel
nut using a 19 mm wrench.
Remove the whole shaft from
the machine housing.
When everything has been
assembled in the order shown
in the illustration above and the
wave washer is in place, it is
time to slide the shaft through
the machine housing.
2
ASSEMBLY: Thread on the
diamond grinding wheel nut
counterclockwise. Hold the dia-
mond grinding wheel with one
hand and tighten the nut with a
19 mm wrench. Note: The nut
is locked counterclockwise
because it has left-handed
threads.
4
3
5
ASSEMBLY: Place the flat drive
wheel washer onto the shaft.
Insert the drive wheel lock pin
into the hole in the shaft. Install
the drive wheel followed by
the honing wheel. Tighten the
nut. Ensure that all parts are
assembled in the order shown
in the illustration.
Finish by reinstalling the grind-
ing wheel. Remember that the
nut on the grinding wheel side
has left-handed threads and is
locked counterclockwise.
2
1