Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the tool (figure 9).
When there is danger of fall-
WARNING
ing down, especially when
working aloft, on vertical building elements
or overhead, always secure the machine
using the provided safety strap. In case of a
power failure or when the mains plug is
pulled, the magnetic holding power is not
maintained.
Before mounting or replac-
WARNING
ing cutting tool or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the power
tool.
Core drill bit
Loosen both screws of the tool holder using
the hex key.
Insert the pilot pin into the cutter.
Insert the cutter with the pilot pin into the
tool holder.
Tighten both screws of the tool holder onto
the flats on the cutting tool using the hex
key.
Do not touch the sharp edges of the core drill
bit. Danger of injury.
Drill bit
The knurled nut has a left-hand thread; turn
clockwise to release!
Loosen the knurled nut and remove the tool
holder by applying a hammer blow to the
positioned drift.
Clean the inside cone of the output shaft and
insert the drill bit.
Fig. 9
5.
2.
3.
4.
1.
2.
3.
en
19
2.
5 mm
5.
1.
Centering pin
4.
Core drill bit
1.
5 mm
4.
Drill bit
Publicidad
