Publicidad
Idiomas disponibles
Idiomas disponibles
Feed (figure 16).
Work only with the absolutely required
amount of feed. Excessive feed can lead to
breakage of the application tool and loss of
the magnetic holding power.
To generate feed, turn the spoke handle
manually while the drill motor is switched
on.
Mounting the spoke handle is described
under „Exchanging the capstan handle posi-
tion".
Instructions for core drilling.
In case of overload, the motor automatically
stops and must be restarted again.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor
and carefully turn the carbide tipped cutter
out counterclockwise.
After each drilling operation, remove the
chips and the slug.
Corrective Action
Error message/
Response of mag-
net button
Indicator lights up
green
Indicator flashes
green
Meaning
Magnetic holding power
possibly sufficient.
Magnetic holding power
possibly insufficient.
Fig. 16
Do not touch the chips with your bare
hands. Always use a chip hook
(6 42 98 160 40 0).
For core drilling in layered material, use a
suitable Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
Corrective action
Always secure the machine with the sup-
plied safety strap.
Always secure the machine with the sup-
plied safety strap.
When working on steel materials where
the material thickness is below 12 mm,
the work piece must be made thicker
with an additional steel plate in order to
ensure the magnetic holding power.
en
25
Publicidad
