Publicidad
Idiomas disponibles
Idiomas disponibles
en
6
Operate the power tool only from grounded
contact sockets that comply with the speci-
fications. Do not use any connection cables
that are damaged; use extension cables
with a grounded contact that are checked at
regular intervals. A ground conductor with-
out continuity can cause an electric shock.
To prevent injuries, always keep your hands,
clothing, etc. away from rotating chips. The
chips can cause injuries. Always use the chip
guard.
Do not attempt to remove the cutting tool if
it still turns. This can lead to serious injuries.
Beware of any concealed electric cables,
gas or water conduits. Check the working
area before commencing work, e. g. with a
metal detector.
Do not work materials containing magne-
sium. Danger of fire.
Do not work CFP (carbon-fiber-reinforced
polymer) and materials containing asbestos.
These materials are considered carcinogenic.
Do not rivet or screw any name-plates or
signs onto the power tool. If the insulation is
damaged, protection against an electric
shock will be ineffective.
Vibration and noise emission values
The vibration and noise emission values
given in these instructions have been mea-
sured according to a measurement method
standardized in EN 62841 and can be used
to compare power tools with each other.
They are also suitable for a preliminary
assessment of vibration and noise exposure.
The given vibration and noise emission
values represent the main applications
of the power tool.
However, if the power tool is used for other
applications, with deviating application tools
or insufficient maintenance, the overall
vibration values and the noise emission val-
Do not overload the power tool or the stor-
age case and do not use it as a ladder or
stand. Overloading or standing on the
power tool or the storage case can lead to
the upward shifting of the center of gravity
of the power tool or the storage case, and its
tipping over.
Do not use accessories which are not specif-
ically designed and recommended by the
power tool manufacturer. Safe operation is
not ensured merely because an accessory
fits your power tool.
Clean the ventilation openings on the power
tool at regular intervals using non-metal
tools. The blower of the motor draws dust
into the housing. An excessive accumulation
of metallic dust can cause an electrical haz-
ard.
Do not transport the machine with lifting
equipment.
Before storage: Remove the application tool.
Store the power tool only in the case or
packaging.
Before putting into operation, check the
power connection and the power plug for
damage.
Always operate the machine with together
with a PRCD (*) personal protection switch.
Before beginning to work, always check the
proper functioning of the PRCD (*) personal
protection switch.
ues may differ. This can significantly increase
the vibration and noise exposure over the
total working period.
For an accurate estimation of vibration and
noise exposure, the durations when the
equipment is switched off or running but
not actually in use should also be taken into
account. This may significantly reduce the
vibration and noise exposure over the total
working period.
Identify additional safety measures to
protect the operator from the effects of
vibration and noise such as: Maintaining the
power tool and accessories, keeping the
hands warm, organization of work patterns.
Publicidad
