John Bean B 300 Manual Del Operador página 110

Trouble shooting
...
7.1.4 H Codes - Warning
H0
Wheel silent running cannot be improved with
optimisation.
H1
Further optimisation is not recommended, but is
possible.
H2
Weight minimisation is recommended, further
optimisation does not bring improvements.
H22
Unclamping is disabled.
The machine is equipped with a clamping device
fi tted with a tie rod on the chuck (e.g. USV or SCA);
unintentional unclamping could damage the tie rod.
H33
The SONAR does not work.
H34
SONAR can not read: guard was lowered too quickly.
H35
SONAR measures data out of range.
H80
Recalibration was not set up. As a result, it cannot be
performed by the operator.
Press the STOP key to clear the message.
Call the service team for machine calibration.
H82
The self-test was disturbed (e.g.: by turning the wheel).
The message is displayed for 3 seconds, then the
measurement must be repeated (max. 10 times) or
aborted by pressing the STOP key.
110