Operation - John Bean B 300 Manual Del Operador

24
5-1
5-2

Operation

5.0 Operation
This chapter describes how to operate the unit in order
to balance a wheel.
The standard balancing runs will be described fi rst. In
chapter 5.11 and up special modes and functions will
be described.
Be sure to be familiar with:
F
- possible dangers, (
F
- the unit, ( 4).
5.1 Clamping a wheel
Fig. 5-1 illustrates the clamping of a conventional car
wheel using a clamping adaptor on the central bore.
Fig 5-2 illustrates the clamping of a car wheel centred
through studs or a car wheel without centre bore using
a universal clamping device.
The range and applications of the clamping means are
described in separate leafl ets.
Fig 5-1 Clamping adaptor to clamp centre bore car
wheels
1 Cone for car wheels
2 Rim
3 Universal drum with clamping nut (quick nut)
4 Clamping nut
Fig. 5-2 Universal clamping device for clamping of car
wheels centred with studs with closed rim.
It can also be used for clamping centre bore wheels
with suitable centring rings (3).
1 Rim
2 Quick–clamping nut
3 Centring ring for closed rim located car wheels
(accessory).
...
1).