John Bean B 300 Manual Del Operador página 50

3
2
50
A
5-24c
5-22
5-23
5-24
Operation
5.9.1.2 Application with gauge arm
For weight application with arm tip, Laser Pointer
will have to be disabled. Weight will be positioned
to the left compared to the contact point (A) of
Gauge on rim Figure 5-24c.
Refer to Figure 5.22
The gauge arm must be used to apply the stick-on
weights.
• Rotate the wheel to the balancing position in the
right plane.
When all the indicators are ON (3, Fig. 5-23), the
WAP indicator will also light up (1-2 Figure 5-23).
• Press the brake pedal to lock the wheel in this
position.
Decide now whether to use the Split Weight Mode
F
SWM ( 5.10.1).
• Clean the application point before applying the
stick-on weight.
• Insert at the centre of the arm gauge a stick-on
weight that complies with the unbalance detected
and remove the adhesive protective strip Figure
5-24.
Note: Once the gauge arm has been removed
and the correct position has been reached,
the unit generates an acoustic signal and the
unbalance value fl ashes.
• Apply the weight to the correct point on the rim.
• Rotate the wheel to the next WAP position (2,
Fig. 5.23), put the stick-on weight on the arm and
apply the weight to the left plane reference point.
• Perform a Test Run.
1
...