Profi Cook PC-ES 1267 Manual De Instrucciones página 19

3. Insert a Nespresso compatible capsule into the capsule
adapter. To do this, proceed as follows:
3.1 Open the flap on the capsule adapter.
3.2 Press the capsule into the adapter with light pres-
sure. The metal tips at the bottom of the adapter
pierce the capsule.
3.3 Close the flap again so that it audibly clicks into
place.
4. Insert the adapter for the capsules into the filter holder.
5. Fit the filter holder to the brew head. Make sure that the
filter holder is firmly seated in the brew head.
6. When the required brewing temperature is reached, all
control lamps light up. Place the cup(s) under the brew
head on the drip tray.
7. Press the or button. The hot water is pressed
through the filter.
8. When no more coffee flows, remove the cup(s).
- Remove the filter holder after each preparation. This
prolongs the life of the rubber seal in the brew head.
9. Detach the filter holder from the brew head.
WARNING:
• Always pull the mains plug out of the socket before cleaning
and wait until the appliance has cooled down.
• Do not immerse the appliance in water. It could cause an elec-
tric shock or fire.
• The steam nozzle is hot immediately after use!
CAUTION:
• Do not use a wire brush or other abrasive objects.
• Do not use harsh or abrasive cleaning agents.
Clean the outside of the appliance with a slightly damp cloth
if necessary – without any additives.
Brew Head and Rubber Seal
Wipe the brew head and the rubber seal with a damp cloth.
Dampen a soft nylon brush beforehand to remove stubborn
dirt. Dry off with a dry cloth.
PC-ES1267_IM
10. To prepare another cup, the capsule must be replaced
with a new capsule:
WARNING: Risk of Burns!
The metal parts on the filter holder and the filter insert
are hot.
Before you can change the capsule, you must cool the
adapter for Nespresso compatible capsules under cold
water.
11. To prepare the next cup(s), proceed as described above.
- The coffee temperature of the first cup prepared and
the following cup(s) may be different.
Hot Water Function
The appliance can also be used to prepare hot water for
tea. To do this, proceed as follows:
1. Fill the water tank with sufficient water and reinsert it.
2. Swivel the steam pipe outwards. Make sure that the
steam nozzle is screwed on.
3. Place a cup under the steam nozzle.
4. Switch on the appliance with the
the appliance is preheated. Turn the controller to the
position / .
The appliance starts dispensing water. The control lamps
for the cups flash and the steam control lamp goes out.
5. After dispensing the desired amount of water (max.
150 ml), set the control back to the position .
Cleaning
Accessories
You can clean the filter holder, filter inserts, drip grid, col-
lection container, measuring spoon, water tank and steam
nozzle in warm rinsing water with a little hand dishwashing
liquid. If necessary, you can use a fine, soft nylon brush.
Rinse with clean water. Dry the parts with a soft cloth.
CAUTION:
These parts are not suitable for cleaning in the dish-
washer. Exposure to heat and harsh cleaners could
cause them to warp or discolour.
button. Wait until
19
22.11.23