Profi Cook PC-ES 1267 Manual De Instrucciones página 20

Water Tank
1. Remove the water tank by pulling it out by the handle.
Reinsert it after cleaning and drying.
- There are two hooks on the water tank.
2. Hook the water tank into the two eyelets on the appli-
ance.
3. Press the water tank down slightly so that the valve
opens.
Steam Nozzle
Clean the steam pipe and the screwed-on steam nozzle im-
mediately after each preparation of milk foam. Milk residues
that have dried up make cleaning more difficult.
1. Unscrew the steam nozzle. Let it soak in the warm rinse
water for a while. This helps to loosen the milk residues.
2. Wipe the steam pipe on the appliance with a damp cloth.
- To loosen dried-on residues, fill a vessel with hot
water. Place it under the steam pipe so that it is
immersed in it.
3. Screw the steam nozzle back onto the steam pipe after
cleaning. Place a heat-resistant empty container under
the steam nozzle. Operate the appliance as described
in "Cappuccino Preparation" points 4 and 5. After this
steam cleaning, the steam nozzle is ready for use again.
Problem
The appliance has no
function.
There is no more coffee
running in.
20
PC-ES1267_IM
Troubleshooting
Possible Cause
The appliance has no power supply.
The appliance is defective.
The water tank is empty.
The water tank is not inserted correctly,
the valve is not open.
The holes in the filter holder and the
outlet on the brew head are blocked.
Air has got into the heating circuit.
The coffee powder is too fine or has
been pressed on too firmly.
The appliance is calcified.
De-scaling
Limescale deposits endanger the function of the appliance.
Therefore, the appliance must be descaled regularly. The
intervals between descaling depend on the hardness of the
water and the frequency of use.
Descale with a commercially available descaling agent, as
recommended for coffee machines.
1. Follow the dosage instructions on the packaging or
package insert.
2. Operate the appliance without the filter holder, as for
espresso preparation, until the tank is empty. Run the
solution through the brew head.
WARNING:
• Rinse out the water tank and run a full tankful of fresh
water through the brew head to rinse out any descal-
ing agent residue.
• Do not use this water for consumption.
Storage
• Clean the appliance as described. Allow the accessories
to dry completely.
• We recommend storing the appliance in its original
packaging if you do not intend to use it for a longer
period of time.
• Always store the appliance out of the reach of children in
a well-ventilated and dry place.
Remedy
Check the power socket with another appliance.
Insert the mains plug correctly.
Check the house fuse.
Contact our service or a specialist.
Switch off the Appliance!
Fill the water tank with fresh water.
Press the water tank firmly on the upper side until
it locks into place.
Clean the filter holder, the filter and the outlet on
the brew head.
Generate steam as described under "Cappuccino
Preparation". Turn the controller in the direction
/ as far as it will go.
Loosen the coffee powder. Distribute it evenly and
press it only lightly with the tamper.
Descale the appliance as described.
22.11.23