Attaching Embroidery Unit; Removing Embroidery Unit - Singer XL-580 Manual De Instrucciones

ATTACHING EMBROIDERY UNIT

before installing embroidery unit.
CAUTION
1. Turn off the machine.
Turn connector cap to the right to open.
unit as far as it will go until it clicks into place.
3. To make sure that the embroidery unit is fully engaged,
hold the handle of the embroidery unit and pull it towards
the left direction, checking that the embroidery unit does
not detach.
Note:
If embroidery unit is not securely installed, the finished
embroidery may be distorted. Make sure that the
embroidery unit is pushed in as far as it will go.
on the embroidery unit while attaching or during
CAUTION
damage to the embroidery unit.

REMOVING EMBROIDERY UNIT

* Turn off the machine.
* Remove embroidery hoop from machine.
the left while pressing release lever.
Note:
2. Turn the connector cap to the left to close for general
sewing.
68
Connector cap
1
Couvercle de connecteur
Tapa de conector
Connector
Connecteur
Carriage
Conector
Chariot
Carro
2
3
Mango
1
Release lever
2
Mango
Release lever