Changing The Needle - Singer XL-580 Manual De Instrucciones

supply by removing the plug from the wall-outlet.
1. Raise the needle bar to its highest position by turning the
2. Loosen the needle clamp screw by turning it toward you.
3. Remove the needle by pulling it downward.
4. Insert the new needle into the needle clamp with the
side toward the back.
5. Push the needle up as far as it can go.
6. Tighten the needle clamp screw firmly with the screw
driver.
prise murale.
tournant le volant vers vous.
6. Resserrer la vis du serre-aiguille fermement.
Pin
Pasador
el volante hacia Ud.
3. Quitar la aguja sacándola hacia abajo.
avec le 4. Insertar la aguja nueva en la barra porta-aguja con el lado
plano hacia la parte posterior.
5. Empujar la aguja lo más arriba posible.
Flat side
Lado plano
Flat
side
toward
the
back
tomacorriente de la pared.
Needle
Lado
plat plano
hacia
vers fuera de
Ud.
21