Singer XL-580 Manual De Instrucciones página 128

Reposition the fabric by pulling it toward the back. Place
of the bottom left alignment stitches of the completed
securing the inner hoop again, check to be sure that the
10. It may be necessary to move the needle slightly after
the bottom left-hand alignment stitches of the completed
use the shift buttons on the control panel to move the
needle in the direction needed. When the needle has been
correctly positioned over the corner of the left alignment
stitches, and the right edge of the fabric is parallel with
OK
begin stitching the next endless design.
When you start sewing, the alignment stitches from the bottom
(left and right) of the previous design and the alignment
stitches at the top (left and right) of the current design should
meet, forming a small "side ways T" shapes (E). This ensures
that your designs will be positioned relative to one another
properly. If the alignment stitches don't meet properly, press
the Start/Stop button to stop embroidering, then press the
Reverse button (located above the Start/Stop button) to back
up your stitches to the beginning again.
Reposition the fabric as necessary, using the shift buttons
to ensure the needle is at the corner of the alignment stitch
on the bottom left-hand side of the completed embroidery
122
Tip!
Left Right Up
E
Clear
Bas
Borrar