Publicidad
Idiomas disponibles
Idiomas disponibles
When clamping a fixture to a truss or other supporting structure in any orientation apart from
hanging vertically with the head pointing downwards, use half-coupler-type rigging clamps.
Do not use G-clamps, quick-trigger clamps or any other type of clamp that does not
completely encircle the supporting structure when fastened.
If there is any danger that this product may cause injury or damage if the primary means of
attachment fails, secure it as described in this user manual with a securely anchored safety
cable that will catch it if it falls. Ensure that all safety cables used for secondary attachment
are in perfect condition, are approved by a professional body such as TÜV for the weight
that they will secure, and that they comply with all locally applicable regulations.
Remove as much slack as possible from the safety cable (by looping it more than once
around the chord of a rigging truss, for example). Make sure that, if a primary means of
attachment fails, the fixture cannot fall more than 20 cm (8 inches) maximum before the
safety cable catches it.
If the safety cable attachment point becomes deformed, do not suspend the fixture. Have
the fixture repaired by an authorized Martin service partner.
Allow enough clearance around the head to ensure that it cannot collide with an object or
another fixture when it moves.
Check that all external covers and rigging hardware are securely fastened.
Block access below the work area and work from a stable platform whenever installing,
servicing or moving the fixture. Make sure that there is no risk of injury from falling parts,
tools or other materials.
Do not operate the fixture with missing or damaged covers, shields or any optical
component.
Do not lift or carry the fixture by its head. Support the fixture by its base only.
In the event of an operating problem, stop using the fixture immediately and disconnect it
from power. Do not attempt to use a fixture that is obviously damaged.
Do not modify the fixture in any way not described in the fixture's user documentation. Install
only parts and accessories that are supplied by or approved by Martin for the fixture.
Refer any service operation not described in this manual to Martin Service or an authorized
Martin service partner.
®
10
Martin
MAC Viper XIP Safety and Installation Manual Rev. B
Publicidad
