Publicidad
Idiomas disponibles
Idiomas disponibles
5. See illustration on right. The battery is located behind a
yellow rubber cover. Pull the yellow cover off the battery
compartment and remove the used battery.
6. Insert the new CR123A battery, respecting the correct
battery polarity (positive terminal facing upwards,
towards the head).
7. Reinstall the yellow rubber cover over the battery
compartment. Check the condition of the seal on the
black cover (or the wireless DMX module, if used) that
fits over the USB port / battery compartment. The seal
must be in perfect condition. If not, contact your Martin
supplier for a replacement. Install the cover (or module), fastening it in position with its two screws.
Check that it is closed securely before reapplying power.
8. Dispose of the used battery responsibly: send to an authorized waste recycling and disposal center.
Lubrication
The MAC Viper XIP does not require lubrication under normal circumstances. Moving parts can be
checked and a long-lasting Teflon-based grease reapplied by a Martin service partner if necessary.
54
®
Martin
MAC Viper XIP Safety and Installation Manual Rev. B
Publicidad
