Publicidad
Idiomas disponibles
Idiomas disponibles
4. Dispose of paper air filters. Do not try to clean or re-use a paper air filter. Clean metal air filters with a
soft brush and vacuum cleaner or compressed air, taking care to avoid damaging the filter mesh. If
metal filters are greasy, you can clean them in a household dishwasher at maximum 50° C (122° F),
short cycle recommended. Dry them completely before reinstalling. The metal filter is designed to be
re-used, but replace it with a new item if it is not in clean, undamaged condition after cleaning.
5. Place the clean air filters into their recesses in the head, making sure that there is no gap for air to
pass around the edges of the filter.
6. Hook the rear end of each filter cover into the head and push the front end into the head until its clip
engages fully. Check that the covers are held securely and cannot fall out of the head.
Base air filters
To service the base air filters:
1. See illustrations below. For each of the two air filters, push on the air filter cover retaining clips
(arrowed) to release them, then remove the filter from the base.
2. Remove dust from each filter with a soft brush and/or low-pressure compressed air. Remove grease
with warm soapy water. You can clean the filters in a household dishwasher at maximum 50° C (122°
F), short cycle recommended.
3. Dry each filter carefully, then push it back into its recess in the base until both retaining clips lock into
place. Make sure that the filter is held securely.
Battery replacement
Warning! Disconnect the fixture from AC power before replacing its battery. Do not attempt to
recharge the battery, or you may create a risk of fire or explosion.
The MAC Viper XIP has a non-rechargeable 3-volt lithium battery that provides power to the control panel
and display when the fixture is not connected to AC mains power. If the battery runs flat, you must replace
it. Do not attempt to recharge it.
The battery is located behind a cover in the USB port / battery compartment next to the control panel on
the base of the fixture. If a wireless DMX module accessory is installed, the battery is behind this module.
To replace the battery:
1. Order Martin P/N 05801011 (CR123A, 3 V lithium battery).
2. Disconnect the fixture from AC mains power and allow to
cool.
3. See illustration on right. Remove the two Torx10 screws
from their holes (arrowed) in the black USB port / battery
compartment cover.
4. Carefully lever the cover off the fixture base with a flathead
screwdriver. Take care not to damage seals.
®
Martin
MAC Viper Safety and Installation Manual Rev. B
53
Publicidad
