Publicidad
Idiomas disponibles
Idiomas disponibles
The latest versions of this Safety and Installation Manual and the fixture's User Manual are
available for download from the MAC Viper XIP area of the Martin website at
www.martin.com. Before you install, operate or service the fixture, check the Martin website
and make sure that you have the latest user documentation for the fixture. Document
revisions are indicated at the bottom of page 2.
Technical Support
If you have questions about how to install or operate the fixture safely, please contact
Harman Professional Technical support:
• For technical support in North America, please contact
HProTechSupportUSA@harman.com
Phone: (844) 776-4899
• For technical support outside North America, please contact your national distributor.
Protection from electric shock
The fixture has an ingress protection rating of IP54 that is applicable in EN/IEC regions
(Europe and other countries). It has a 'Damp locations' rating that is applicable in the USA
and Canada. Damp locations are considered to be partially protected locations under stage
and event canopies, marquees, tents, roofed open bars and similar locations.
An IP54 rating means that a fixture can withstand rain, splashing water, condensation etc.
but not high-pressure water jets. The fixture is designed to be used under any weather
conditions, but it must not be exposed to an artificially high volume of water (in a fountain,
waterfall or shower, for example). The most extreme rain ever recorded had a volume of 400
mm / 16 inches per hour. The fixture is designed to withstand such a condition. A fountain,
waterfall or shower can create a much bigger volume of water (up to 15 000 mm / 50 feet
per hour). The fixture is not designed to withstand conditions like these.
Do not immerse the fixture in water.
Shut down power to the fixture immediately if extreme conditions such as flooding arise.
Do not expose the fixture to high-pressure water jets.
The fixture is designed for temporary outdoor installation only. Installing it permanently in an
outdoor location could cause accelerated aging that would potentially affect its IP54 rating.
This would create a potential safety hazard and a risk of damage. Do not use the fixture for
permanent outdoor lighting.
Do not install the fixture in locations where the air is aggressive to materials (where the air
has a high salt or chlorine content, close to the sea or a swimming pool, for example).
Do not operate the fixture if the ambient temperature (Ta) falls below -10° C (14° F). Do not
operate the fixture in ambient temperatures below 5° C (41° F) if ice is forming on the fixture.
Protect the fixture from snow and ice. Freezing water may deform the fixture's housing,
creating a safety hazard. Monitor weather conditions and take all appropriate safety
precautions if a freezing hazard is forecast or present.
The fixture is rated IP54 / 'Damp locations' only when the following types of connector are
used on cables connected to the fixture:
• Neutrik powerCON TRUE1 NAC3FX-W-TOP connector at the power IN socket,
• Neutrik powerCON TRUE1 NAC3MX-W-TOP connector at the power THRU socket,
• Neutrik TOP series 5-pin locking XLR connectors at the XLR (DMX, RDM) data sockets,
and
• Neutrik TOP series etherCON connectors at the Ethernet (Art-Net, sACN) data sockets.
Use only these connector types and use only cables that are suitable for the given
application with respect to humidity, water and sunlight resistance.
The power and data connectors are fitted with rubber caps to protect from water ingress.
Keep rubber caps installed at all times on all connectors that are not in use.
6
®
Martin
MAC Viper XIP Safety and Installation Manual Rev. B
Publicidad
