Storing Stations In Memory; Fm Station Automatic Preset: Ssm - JVC KD-LX100 Manual De Instrucciones

2
Press and hold
"M" (manual) starts flashing on the
display.
3
Tune into a station you want while "M"
is flashing.
Press
stations of higher frequencies.
Press 4
stations of lower frequencies.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing until you release the button.
When an FM stereo broadcast is hard to
receive:
1
Press MODE while listening to an FM stereo
broadcast (the ST indicator lights up while
receiving an FM stereo broadcast).
2
Press MONO, while "MODE" is still on the display,
so that the MO indicator lights up on the display.
The sound you hear becomes monaural but the
reception will be improved (the ST indicator goes
off).
Each time you press the button, the MO indicator
lights up and goes off alternately.
¢ or 4
until
¢ to tune into
to tune into

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations

FM station automatic preset: SSM

You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3).
1
Select the FM band (FM1–3) you want
to store FM stations into.
1 Press SOURCE to select
2 If necessary, press
Each time you press the button, the band
changes as follows:
FM1 FM2
2
Press and hold both buttons for more
than 2 seconds.
"SSM" appears, then disappears when automatic
preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons
— No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
tuner as the source.
BAND repeatedly to
select the band.
FM3 AM
9