Husqvarna PP 8 Manual Del Usuario página 32

2. Push the ON button on the power pack. There is a
fixed green light on the LEDs (1, 2, 3).
A
1 2 3
To start the product
1. Start the power pack. Refer to
pack on page 32 .
2. Start the remote control. Push the ON/OFF button
on the remote control, information is shown on
the display. Refer to the operator's manual for the
connected wall saw for more information.
3. Select which blade to use. Confirm with the right
button.
32
To start the power
4. Decide in which direction the blade should move.
Choose A or B. Confirm with the right button.
5. Start the blade rotation on the wall saw. Refer to
start the blade rotation on page 33 .
To start the power pack
1. Connect the water supply to the power pack. Refer
To connect the water supply to the power pack on
to
page 26 .
2. Connect the power pack to a power source. Refer
To connect the power pack to a power source on
to
page 26 .
3. The LED (2) flashes which means that the power
pack is in stand-by mode.
1 2 3
To
2092 - 002 - 15.01.2024