Publicidad
Idiomas disponibles
Idiomas disponibles
To adjust the blade guard guide
A
B
1. Loosen the nuts on the 2 adjustable guide wheels
(A).
2. Attach the blade guard guide to the blade guard.
3. Turn the camshafts with a 22 mm wrench until the
guide wheels touch the track (B).
4. Hold the camshaft in position with a 22 mm wrench
and tighten the nut with a 16 mm wrench.
5. Make sure that the wheels turn easily and that there
is no play in the blade guard guide.
To adjust the guide wheels
In order for the saw to run stably and saw a straight
cut, the four guide wheels must rest against the rail and
not have too much play. The guide wheels should be
adjusted on the side shown in the figure, the opposite
side is a fixed position that should only be adjusted
during maintenance at an authorized Huqvarna service
workshop.
If the saw has too much play, the guide wheels must be
adjusted as follows:
1. Use a 13 mm spanner to loosen the nut (A).
2. Screw in the stop screw (B) with a 4 mm hex key
until the guide wheels rest on the rails and there is
no more play.
44
3. Hold the stop screw (B) in this position with the
hex key while tightening the nut (A) to lock the stop
screw.
A
B
Maintenance of the remote control
WARNING:
control from the power supply and wait
minimum 5 minutes before you start the
maintenance
CAUTION:
washer to clean the remote control . The
high pressure can cause damage to the
seals and cause water and dirt to come into
the remote control .
To clean the remote control daily
CAUTION:
the electrical components.
•
Clean the outer parts of the remote control with
a moist cloth. Clean the inner parts of the remote
control with compressed air.
To examine the remote control
1. Do a visual inspection of the remote control for
cracks and other damages.
2. Make sure that all seals, couplings, connections and
cables are in good condition and not damaged.
3. Examine the switches and controls for damages.
4. If there are any damages or the remote control does
not operate correctly, speak to an approved service
agent.
Disconnect the remote
Do not use a high pressure
Do not use water directly on
2092 - 002 - 15.01.2024
Publicidad
