Husqvarna PP 8 Manual Del Usuario página 31

Note:
Secure each section with wedges or
anchors to make sure that the sections do not
fall or jam the blade.
b) Do the 2 vertical cuts (E).
WARNING:
the last cut, make sure that the
block part that remains and to which
the track is attached, is stable. Use
wedges to secure the smaller block
parts.
To prepare the product for near floor operation
1. Loosen only the attachment that is necessary for the
operation.
2. Remove the blade guard part.
2092 - 002 - 15.01.2024
Before you make
3. Do near floor operation. Refer to
on page 32 and to To operate the wall saw on page
28 .
To do a check of the power pack indication
LEDs
1. Make sure that the LED (2) flashes when you have
connected the power pack to a power source. This
means that the Power Pack is in stand-by mode.
1 2 3
To start the product
31