2. Operation mode tab
3. Quick action bar
4. Bottom bar
5. Product view
Symbols in the top bar on the display
1
2
Position
Function
1
No radio signal. No connection with the
product.
2
Radio signal strength.
3
The radio signal is blocked.
4
The CAN bus cable is attached between
the product and the remote control.
5
State of charge. When the battery symbol
is yellow, the state of charge is 11–20%.
When the battery symbol is red, the state of
charge is less than 10%.
Symbols in the operation mode tab on the display
1
The operation mode tab becomes orange (3) when the
blade starts to turn.
8
3
4
5
2
3
Position
Function
1
Operation mode counterclockwise is selec-
ted.
2
Operation mode clockwise is selected.
3
Operation mode clockwise is started.
Symbols on the power pack
WARNING: Not careful or incorrect use
can result in injury or death to the operator
or others.
Read the manual carefully and make
sure that you understand the instructions
before you use the product.
Always put on hearing protection, eye
protection and breathing protection.
Inspection and/or maintenance must be
done with the motor stopped and the plug
disconnected.
Energized parts.
The product or package of the product
is not domestic waste. Recycle it at
a recycling station for electrical and
electronic equipment.
Note:
Other symbols/decals on the product refer to
special certification requirements for some markets.
Symbols on the wall saw
WARNING: This product can be
dangerous and cause serious injury or
death to the operator or others. Be careful
and use the product correctly.
Read the manual carefully and make
sure that you understand the instructions
before you use the product.
2092 - 002 - 15.01.2024