Publicidad
Idiomas disponibles
Idiomas disponibles
The emergency stop button on the power pack also
disconnects the power tool from the power supply.
To do a check of the power pack emergency stop button
1. Turn the emergency stop button (A) on the power
pack clockwise to make sure that is released.
2. Start the connected power tool.
3. Push the emergency stop button (B) on the power
pack.
4. Make sure that the power tool stops. Also make sure
that the green LED lights on the power pack go out
and that the red LED light flashes.
A
B
Remote control machine stop button
The machine stop button is used to quickly stop the
power tool.
2092 - 002 - 15.01.2024
The machine stop button decreases the speed of the
connected power tool. The machine stop button also
disconnects the power tool from the power supply.
The machine stop button can not be used when the
power tool is operated manually.
CAUTION:
stop button on the remote control as the
stop button for the power tool.
To do a check of the remote control machine stop button
1. Turn the emergency stop button on the power pack
clockwise to make sure that it is released.
2. Turn the machine stop button on the remote control
clockwise to make sure that it is released.
3. Push the ON/OFF button on the remote control.
4. Push and hold the toggle switch on the remote
control to the right and at the same time push the
potentiometer to make the saw blade rotate.
5. Push the machine stop button on the remote control.
6. Make sure that the saw blade stops.
RCD
The RCD is a protection for the operator if an electrical
fault occur.
When the power pack is plugged in to a 3 phase
connection, the RCD integrated to the power pack is
active.
When the power pack is plugged in to a 1 phase
connection, the RCD integrated to the power pack is
not active. You instead need to use a separate 1 phase
Accessories on page 61 .
adapter. Refer to
Do not use the machine
15
Publicidad
