Publicidad
Declaration of Incorporation of Partly Completed Machinery
in accordance with Schedule 2 Part 2 Annex II, section 1.B. of the Directive 2008 No. 1597
Supply of Machinery (Safety) Regulations 2008
For the following product:
Type 2413 Actuator
We certify that the Type 2413 Actuator is partly completed machinery as defined in the in Directive 2008 No.
1597 Supply of Machinery (Safety) Regulations 2008 and that the safety requirements stipulated in Annex I,
1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.4 and 1.3.7 are observed. The relevant technical documentation described in An-
nex VII, (Part 7 of Schedule 2) part B has been compiled.
Products we supply must not be put into service until the final machinery into which it is to be incorporated has
been declared in conformity with the provisions of the Directive 2008 No. 1597 Supply of Machinery (Safety)
Regulations 2008.
Operators are obliged to install the products observing the accepted industry codes and practices (good engi-
neering practice) as well as the mounting and operating instructions. Operators must take appropriate precau-
tions to prevent hazards that could be caused by the process medium and operating pressure in the valve as
well as by the signal pressure and moving parts.
The permissible limits of application and mounting instructions for the products are specified in the associated
mounting and operating instructions; the documents are available in electronic form on the Internet at
www.samsongroup.com.
For product descriptions refer to:
-
-
Referenced technical standards and/or specifications:
-
-
Comments:
-
-
Persons authorized to compile the technical file:
SAMSON AG, Weismüllerstraße 3, 60314 Frankfurt am Main, Germany
Frankfurt am Main, 27 April 2022
Stephan Giesen
Stephan Giesen
Director
Product Management
Classification: Public · SAMSON AKTIENGESELLSCHAFT · Weismuellerstrasse 3 · 60314 Frankfurt am Main, Germany
5
Type 41-23 Universal Pressure Reducing Valve: Mounting and Operating Instructions EB 2512
Type 41-73 Universal Excess Pressure Valve: Mounting and Operating Instructions EB 2517
VCI, VDMA, VGB: "Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für Armaturen, Mai 2018"
[German only]
VCI, VDMA, VGB: "Zusatzdokument zum Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für
Armaturen vom Mai 2018" [German only], based on DIN EN ISO 12100:2011-03
See mounting and operating instructions for residual hazards.
Also observe the referenced documents listed in the mounting and operating instructions.
Peter Scheermesser
Director
Product Maintenance & Engineered Products
Certificados
Revision 00
Page 1 of 1
Publicidad
