Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8
9
:
Set the choke lever (8):
g
For cold start to
For warm start to e
– also use this position if the engine
has been running but is still cold.
:
Press fuel pump bulb (9) at least five
times even if bulb is filled with fuel.
FS 75
8
:
Put the unit on the ground:
It must rest securely on the engine
support and deflector.
Check that the cutting tool is not
touching the ground or any other
obstacles.
:
Make sure you have a firm footing.
:
Hold the unit with your left hand on
the control handle and press it down
firmly – your thumb should be
under the control handle.
Do not stand or kneel on the drive
tube! This could permanently
damage the drive tube.
English / USA
:
Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull.
Do not pull out the starter rope all
the way – it might break.
:
Do not let the starter grip snap
back – guide it slowly into the
housing so that the starter rope can
rewind properly.
:
Continue cranking until the engine
runs.
When engine begins to fire:
:
Move choke lever to e
:
Continue cranking.
As soon as engine runs:
:
Blip the throttle trigger –
the slide control moves to the run
position # – and the engine returns
to idling speed.
Make sure carburetor is correctly
adjusted – the cutting tool must not
rotate when the engine is idling.
Your power tool is ready for
operation.
21
Publicidad
Capítulos
Tabla de contenido
