Stihl FS 75 Manual De Instrucciones página 29

English / USA
7
Replacing the Starter Rope
:
Use a screwdriver to pry the cap (6)
out of the starter grip.
:
Remove remaining rope from the
rotor and grip, making sure the
ElastoStart sleeve is not pushed out
of the grip.
:
Tie a simple overhand knot in the
end of the new starter rope (see
Specifications) and then thread the
rope through the top of the grip and
the rope bushing (7).
: Refit the cap in the grip.
28
6
: Pull the rope through the rotor and
secure it with a simple overhand
knot.
:
Go to "Installing the rope rotor".
Replacing a Broken Rewind
Spring
Two types of replacement spring are
available from the factory:
– A ready-to-fit rewind spring secured
with a wire retainer.
– A rope rotor with pre-installed
rewind spring.
Installing the ready-to-fit rewind
spring
:
Lubricate the spring with a few
drops of non-resinous oil – see
"Special Accessories" – do not open
the wire retainer!
: Carefully remove the parts of the old
spring from the starter cover and
rope rotor.
:
Insert the new rewind spring in the
rope rotor and, at the same time,
engage the outer spring loop in the
rotor's recess – the wire retainer
slips off in this process.
If the spring pops out and uncoils,
refit it in the counterclockwise
direction, starting outside and
working inwards.
:
Go to "Installing the Rope Rotor".
Installing rope rotor with rewind
spring
:
Carefully unpack the new rope rotor
with rewind spring. The spring may
pop out if not handled with care –
risk of injury.
: Lubricate the spring with a few
drops of non-resinous oil – see
"Special Accessories".
:
Go to "Installing the Rope Rotor".
FS 75