Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
4
3
:
Use green-coded nylon line with a
diameter of 0.080" (2 mm).
:
Cut two 10-ft (3m) lengths of nylon
line from the reel**.
:
Insert the end of each line (3) in the
holes (4) in the spool.
:
Bend the ends of the lines over the
edge of the holes to form a hook.
**
see "Special Accessories"
FS 75
5
:
Straighten out the nylon lines and
wind them tightly onto the spool –
one nylon line in each chamber.
:
Engage the ends of the nylon lines
in the notches (5).
Assembling the Mowing Head
Check that the compression spring
is installed (see "Mounting the
Mowing Head").
5
6
:
Thread the ends of the lines (6)
through the sleeves (7) and push
spool (2) into the head so that it
snaps into position.
Nylon lines must disengage from
notches (5) as the spool is pushed
into position.
:
Pull out the ends of the lines as far
as stop.
:
Mount the mowing head on the
machine.
English / USA
2
6
7
31
Publicidad
Capítulos
Tabla de contenido
