Adjusting The Device; Connecting The Device, Performance Check - DJO Global ARTROMOT-K1 Modo De Empleo

4. Adjusting the device

Note: For a better understanding of each
step, please fold out pages III and VIII.
4.1 Connecting the device,
performance check
The equipment supplied includes these
items:
base unit, programming unit (20), patient
chip card (21 - ARTROMOT-K1 versions
with chip card only), power cord (not
shown), operating instructions
1. Connect the programming unit (20) to
the provided socket (15) by plugging it in
and closing the bayonet lock. (With pa-
tient chip card versions, insert the chip
card into the slot in the programming
unit)
2. Connect the power cord to socket (16)
of the device and mains plug to a wall
outlet with a non-fused earthed wire
(100 to 240 Volt, 50/60 Hz).
3. Turn the power switch (18) on.
4. Follow these steps to set the carriage to
the home position.
ARTROMOT®-K1
without patient chip card
Press the MENU key on the pro gram ming
unit until you reach program level 3 (stand-
ard model) or program level 5 (Comfort
model).
Press the "New Patient" parameter key.
.
Press the START key. The CPM device au-
tomatically enters the home position.
ARTROMOT®-K1
with patient chip card
Initial adjustment for new patients Insert
the original patient chip card (21) into the
programming unit (20).
ORMBS-12006_Artromot_K1_Comfort_2012_rz.indb 48
Press the MENU key on the pro gramming
unit until you reach program level 3 (stand-
ard model) or program level 5 (Comfort
model). Press the "New Patient" parameter
key.
Press the START key. The CPM device au-
tomatically enters the home position.
Adjustment with programmed chip card
Insert the original patient chip card (21)
into the programming unit (20).
Press the START key.
The CPM device automatically enters the
home position.
Performance check
If the programming unit can be operated
as described above and ARTROMOT®-K1
enters the home position (for home posi-
tion values, refer to sections 5.3 and 5.5),
the device has passed the performance
check.
The device also runs performance checks
regularly during operation. This is what
happens, if a problem is identified:
− An audio signal sounds.
− The device switches off immediately.
− The message "ERR", accompanied by a
code number (e.g. ERR 5), appears on
the display.
In this situation, you may attempt to
restart the unit by turning it briefly off and
on again with the power switch. With the
unit switched off, check that all plugs are
correctly connected. Switch the unit on
again: if the error message persists, have
the unit inspected by a Service technician,
before using it again.
48
18.05.12 17:27