Transport - DJO Global ARTROMOT-K1 Modo De Empleo

Warning!
m
Patient hazard –
equipment malfunction and damage
− Refer repair and maintenance to
authorized persons. Persons are
authorized after training by a special-
ist trained and commissioned by the
manufacturer.
DJO Global will make all documents
required for servicing, such as circuit
diagrams, parts lists, descriptions or
calibration instructions, available to
authorized experts.
These checks should be performed by
persons with adequate training and expe-
rience. Damaged and worn parts must im-
mediately be replaced with original spare
parts by authorized staff.
The device does not require additional
regular maintenance.
Fuse replacement
Warning!
m
Patient hazard –
malfunction and damage
The replacement of fuses must be
referred to specialists as defined in IEC
60364 or other applicable standards
(e.g. biomedical technicians, electri-
cians, electronics installers).
Fuses used must be T1A H250Vac
fuses.
ORMBS-12006_Artromot_K1_Comfort_2012_rz.indb 61

6.3. Transport

Follow these steps to prepare the
ARTROMOT®-K1 for transport:
1. Adjust the femur length to 49 cm and
the tibia length to 42 cm.
2. Select the "Transport setting"
from the menu (refer to 5.3 for details).
3. Push the power switch to turn off the
ARTROMOT®-K1.
4. Disconnect the power cord and the
programming unit.
5. The device must be stored in its original
shipping box for transport. DJO Global
cannot be held liable for damage in
transit, if theoriginal shipping box was
not used.
6. Set the footplate to a horizontal
position.
7. Now slide the polystyrene pads onto the
ARTROMOT®-K1.
8. Place the power cord at the bot-
tom of the box before inserting the
ARTROMOT®-K1 including the polysty-
rene pads.
9. Put the programming unit (20) in the
supplied box, and store both in the
ARTROMOT®-K1 box.
Programming unit
61
Power cord
18.05.12 17:27