DJO Global ARTROMOT-K1 Modo De Empleo página 63

n total therapy time
ARTROMOT®-K1 models without
patient chip card
The total therapy time is the added sum
of operating hours.
If the device is used by only one patient,
this time is equivalent to the duration of
all the patient's therapy sessions.
Under menu item "total therapy time"
of ARTROMOT®-K1 models with chip
card you can view each patient's total
therapy time (duration of all the pa-
tient's therapy sessions).
Deleting the stored therapy time
Press and hold the parameter key for
5 seconds or select the New Patient
function.
LEVEL 5:
n transport setting
With this function, the carriage will
move to a position optimally suited
for packing the CPM device. Set the
femur length on 49 cm and the lower
leg on 45 cm.
Select the function and press the START
key. The carriage moves to the transport
position. (see 6.3)
n new patient
With this function, the CPM device will
move to the home position, allowing the
mechanical settings to be completed.
Select the function and press the START
key. The carriage moves to the home
position.
With ARTROMOT®-K1 devices with
patient chip card, the factory defaults
will be restored. All stored values will be
deleted.
The carriage will stop in the home
position.
The New Patient (home position) func-
tion selects the following settings:
− extension:
− flexion:
− speed:
− warm up:
− extension pause:
ORMBS-12006_Artromot_K1_Comfort_2012_rz.indb 59
− flexion pause:
− timer:
− reverse on load:
− total therapy time:
− stretch extension:
− stretch flexion:
− EROM repeat extension:
− EROM repeat flexion:
− Comfort protocol:
− workout protocol:
− EMS control:
− therapy documentation:
n therapy documentation
ARTROMOT®-K1 devices of the Com-
fort series with patient chip card have
a special documentation function which
provides a log of all therapy sessions.
The carriage run times as well as the
range of motion of the sessions are
recorded.
The collected data are presented graphi-
cally in the form of a coordinate system
(X-axis = range of motion/Y-axis = time)
where the upper curve illustrates the
trend of the flexion movement and the
lower curve the trend of the extension
movement.
n Service menu
For service purposes only, refer to Serv-
ice Manual.
Reminder:
You save the set parameter values by
pressing the STOP key.
25°
35°
50 %
disabled
0
59
0
continuous operation
25
0
disabled
disabled
disabled
disabled
disabled
disabled
disabled
reset
18.05.12 17:27