Programming Artromot®-K1 Standard Models - DJO Global ARTROMOT-K1 Modo De Empleo

Patients with
a programmed chip card
− Insert the chip card (the patient is not
yet positioned on the CPM device).
− Perform the mechanical adjustments of
the CPM device (femur length, etc.).
− Position the patient on the CPM device
and press the START key to initiate
therapy.
5.2 Programming
ARTROMOT®-K1
standard models
Different programming levels are provided
to program the ARTROMOT®-K1 Standard
models.
You change between levels by pressing the
MENU key.
The display always indicates on which level
you are.
The following treatment values, settings
and information can be entered/viewed
on the programming unit (20):
LEVEL 1:
− extension
(stretching the knee)
− flexion
(bending the knee)
− speed
− warm up protocol
LEVEL 2:
− extension pause
− flexion pause
− therapy timer
− reverse on load
(feature for patient safety)
ORMBS-12006_Artromot_K1_Comfort_2012_rz.indb 52
LEVEL 3:
− transport setting
− new patient
− total therapy time
− Service menu
Note!
− While you adjust the extension/
flexion values, the CPM device will
move to the set range. This allows
you to easily and quickly determine
the ROM where the patient does not
experience pain.
− Special functions can be programmed
and retrieved with ARTROMOT®-K1
Comfort devices (see sections 5.4 and
5.5).
− Only ARTROMOT®-K1 chip card
models allow therapy protocols to be
saved to an inserted chip card.
MENU
MENU
52
18.05.12 17:27