English
Approved Cutting
Attachments
1
1
Blade (marked 4180/00)
14
Mounting the Loop Handle
Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
Adjusting the Loop Handle
1
Use the combination wrench to
N
loosen the screw (1).
Turn the handle to the vertical
N
position.
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
Slide the handle to the required
N
position.
Tighten down the screw with the
N
combination wrench so that the
handle cannot be rotated on the
drive tube.
FB 131