Connecting Speakers; How To Connect - Yamaha DSP-A1 Manual De Instrucciones

CONNECTING SPEAKERS

Right
Right
Front effect speakers

How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are
faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and –
markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or
speakers.
Red: positive (+)
Black: negative (–)
2
1
18
Main speakers
CAUTION
MAIN
FRONT
Left
Unscrew the knob.
Insert the bare wire.
[Remove approx. 5mm
3
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Use speakers with the specified impedance shown on the
rear of this unit.
Center speaker
Left
SPEAKERS
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
A B
CENTER
REAR
(SURROUND)
COUPLER
MAIN CH CENTER SUBWOOFER FRONT
(SURROUND)
PRE MAIN
OUT IN OUT MONO SPLIT
OUT IN
<
U.S.A., Canada, China, Australia and General models
>
only
Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
Rear speakers
Right
+
A B
A OR B
REAR
Subwoofer system
Left